Μερικό σύνολο : €0.00
●Use for T-REX600. ●3-axis gyroscopic flybarless system to simulate the stability of mechanical flybar system, yet at the same time achieving agile 3D performance. ●Utilizes Silicon Micro Machine (SMM) sensors for excellent stability. ●12 bit processors providing ultra high resolution, resulting in highly precise controls ●Software upgradable through PC interface adapter (sold separately) ●Simplistic setup process without the need of external devices. Setup is done through 5 steps and 2 sensitivity adjustments. Rudder setup is identical to GP780 gyro, minimizing learning curve. ●Flybarless system dramatically improves 3D power output and efficiency, resulting in reduced fuel or electricity consumption. ●Highly sensitive gyroscopic sensors combined with advanced control detection routine providing higher hovering and aerobatic stability than other flybarless system. ●Suitable for all CCPM and mechanical mixing system. ●Comaptible with helicopter of all sizes from T-Rex 250 to T-Rex 700. ●Innovative Pitch Gau as an aid to facilitate pitch adjustments. ●High frame rate signal output for faster and higher precision servo response. ●Capable to operate between 3V to 8.4V, compatible with high voltage servos. ●Small footprint, light weight, minimalists and reliable design. ●Suitable Voltage Range:DC 3~8.4V ●Current Comsumption:DC11.1-22.2V 3-6cell Li-Po ●Flip and Roll rate detection speed: :±300degrees/sec ●Rudder rate detection speed:±500degrees/sec ●Sensor resolution: 12bit ●Operating temperatur:-20℃~65℃ ●Operating humidity:0%~95% ●RoHS certified ●Dimension: Control box:42x26.5x14.5mm Sensor:22.3x21.7x14mm ●Weight: Control box:16g Sensor: 9g Accessories ●Main Rotor head Set x1 ●Flybarless control unit x1 ●Flybarless Sensor x1 ●Screw bag x1 ●Linkage rod A x2 ●Linkage ball A x2 ●Head Stopper x1 ●Pitch Gauge x1 ●Mixing base assembly x1 ●Sensor mounting foam x2 ●Signal extension wire 100mm x1 ●Signal extension wire 220mm x1 ●F servo horns x3